This Permatex Gasket Maker is a single component, medium-strength, thixotropic, anaerobic sealant that cures rapidly. The gasket maker sealant cures when confined in the absence of air between close fitting aluminum surfaces. It provides a tough, resilient, solvent and temperature resistant seal that flexes with flange movement caused by vibration, pressurization, or thermal changes.

• This single component, medium-strength, thixotropic, anaerobic sealant cures rapidly
• Delivers a tough, resilient, solvent, and temperature resistant seal that flexes with flange movement caused by vibration, pressurization, or thermal changes
• Cures when confined in the absence of air between close fitting aluminum surfaces
• The automobile gasket maker does not require mixing
• Non-corrosive to aluminum or cast iron parts for safe use
• Cannot cure outside of the joint
• The non-corrosive gasketing material is designed primarily for use on aluminum, iron, and steel flanged mating surfaces
• Ideal for on-the-spot and emergency repairs or when a conventional gasket is unavailable
• Fills gaps up to .015 in. and cures to a solvent-resistant seal that will not tear or decay during service
• The parts of this medium-strength gasket maker disassemble easily even after extended service
• Old gasket material can be removed in minutes with a simple putty knife for convenience
• This motorcycle gasket maker is also OEM specified
• Suggested applications for automobiles include: machined aluminum metal components, transmission pans, transmission case covers, transaxle casings, transfer cases, split crankcases, pumps, and housings
• Suggested applications for motorcycles include: machined aluminum metal components; transmission pans, transmission case covers, transaxle casings, axle covers, gear cases, split crankcases, pumps, housings, and with O-ring replacement
• Suggested marine applications include: crank case flanges drive unit joints and with O-ring replacement
• Suggested heavy-duty applications include: case covers, power divider shaft housings, input/output power shafts, PTO covers to housing, cover housing gasket, differential, assembly to rear axle housing, power dividers, and axle shaft flanges
• Volume: 50 ml tube
• NSF White Book registered for assurance
• Gasket-making directions: Clean both flange surfaces and remove paint, dirt, grease or old gasket completely. Spray Permatex Surface Prep activator on one surface only and allow it to dry 1-2 minutes. Apply a continuous bead of sealant to the unprimed surface. Assemble the mating surfaces with minimal lateral movement. Excess sealant can be wiped away with a cloth and shop solvent.
• Gasket-dressing directions: Clean both flange surfaces and remove paint, dirt, grease or old gasket completely. Spray Permatex Surface Prep activator on one surface only and allow it to dry 1-2 minutes. Completely cover both sides of the pre-cut gasket with sealant and place the coated gasket on the flange. Assemble mating surfaces with minimal lateral movement.